According to the 2010 BCI Failure Mode Study, starter batteries have become more heat-resistant over the past 10 years. In the 2000 study, a change of 7°C (12°F) affected battery life by roughly one year; in 2010 the heat tolerance has widened to 12°C (22°F). In 1962, a starter battery lasted 34 months, and in 2000 the life expectancy had increased to 41 months. In 2010, BCI reports an average age of 55 months of use. The cooler North attains 59 months and the warmer South 47 months.
Cranking the engine poses minimal stress on a starter apple a1175 battery. This changes in a start-stop function of a micro hybrid. The micro hybrid turns the IC engine off at a red traffic light and restarts it when the traffic flows. This results in about 2,000 micro cycles per year. Data obtained from car manufacturers show a capacity drop to about 60 percent after two years of use in this configuration. To solve the problem, automakers are using specialty AGM and other variations that are more robust than the regular lead acid. Read more about Alternate Battery Systems. Figure 5 shows the drop in capacity after 700 micro cycles. The simulated start-stop test was performed in Cadex laboratories. CCA remains high.
Figure 5: Capacity drop of a flooded starter battery when micro cycling Start-stop function on a micro hybrid stresses the battery; the capacity drops to about 50 percent after two years of use. AGM is more robust for this application. Courtesy of Cadex, 2010 |
The cell voltages on a apple a1185 battery string must be similar, and this is especially important for higher-voltage VRLA batteries. With time, individual cells fall out of line, and applying an equalizing charge every six months or so should theoretically bring the cells back to similar voltage levels. While equalizing will boost the needy cells, the healthy cell get stressed if the equalizing charge is applied carelessly. What makes this service so difficult is the inability to accurately measure the condition of each cell and provide the right dose of remedy. Gel and AGM batteries have lower overcharge acceptance than the flooded version and different equalizing conditions apply. Always refer to the manufacturer’s specifications.
Water permeation, or loss of electrolyte, is a concern with sealed lead acid batteries, and overcharging contributes to this condition. While flooded systems accept water, a fill-up is not possible with VRLA. Adding water has been tried, but this does not offer a reliable fix. Experimenting with watering turns the VRLA into unreliable battery that needs high maintenance.
Flooded lead acid batteries are one of the most reliable systems. With good maintenance these batteries last up to 20 years. The disadvantages are the need for watering and providing good ventilation. When VRLA was introduced in the 1980s, manufacturers claimed similar life expectancy to flooded systems, and the telecom industry switched to these maintenance-free batteries. By mid 1990 it became apparent that the life for VRLA did not replicate that of a flooded type; the useful service life was limited to only 5–10 years. It was furthermore noticed that exposing the batteries to temperatures above 40°C (104°F) could cause a thermal runaway condition due to dry-out.
A new lead acid battery should have an open circuit voltage of 2.125V/cell. At this time, the apple powerbook g4 12 battery is fully charged. During buyer acceptance, the lead acid may drop to between 2.120V and 2.125V/cell. Shipping, dealer storage and installation will decrease the voltage further but the battery should never go much below 2.10V/cell. This would cause sulfation. Battery type, applying a charge or discharge within 24 hours before taking a voltage measurement, as well as temperature will affect the voltage reading. A lower temperature raises the OCV; warm ambient lowers it.
No comments:
Post a Comment